Advertisements

DIY Fig Rig

305393447_b85d0c36db_t.png

I saw a post the other day on DVGuru.com about a DIY fig rig, I was amazed, and had to try. The results were great, and I am so happy with them. Images can be found here.

I thought that I would add my parts list, and some of the things that made it easy for me on this nice little DIY.

1x Five foot piece of 3/4 PVC pipe

10x 3/4 PVC chevron angle pieces umm… You know what I am talking about.

2x 3/4 PVC T’s

1x 3/4 PVC X

2x 3/4 PVC Plugs with a 1/4 inch whole drilled in it

1x 4-1/4 – 20 Carriage bolt

2x 1/4 inch fender washers

2x 1/4 inch wing-nuts

That is about it. The next step is trimming all of the PVC pipe to the correct lengths. With the five foot section of pipe, cut to these lengths.

5x 6 inches

2x 3 inches

4x 2 1/2 inches

2x 1 1/2 inches

That is all the cutting. About the easiest way that to put it all together is by doing it in two halves. That way you can press them together. After you get them put together, you screw the wing-nut to the bottom, and then add the washer. But the bolt all the way through, and unless you are adding the camera right away, put the other wing-nut on the top.

This was a really simple, cool project. I was anxious to get this started, as I wanted to take it skiing at Brighton the next day. You can check out the video here.

Special thanks to Shygantic for the specs.

Advertisements

3 Comments

Leave a Reply to jondh Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: